Care; Troubleshooting And Faq; Troubleshooting - Tivoli Audio MODEL SUB Manual

6. You will see your unit download and install the firmware update. Once the update is finished, your
speaker will turn itself off. Turn your unit back on, and it is ready for use.
A dry cloth is recommended to clean the back and wooden cabinet of your Model Sub. A lint
roller can be used to clean the fabric on the front. Do not expose to water.
1. The LED is blinking green slowly. Your speaker is having trouble connecting to a network it was
previously set up for. Check to make sure the network is still active. If the network is still active,
try turning off the speaker and turning it back on. If that does not work, perform a factory reset
(hold down the Setup and Party Mode buttons for 3 seconds) and repeat the setup process for the
speaker.
2. The LED is blinking green fast. Your speaker has not been set up for a wireless network and it is
in setup mode. Refer to the setup directions in either the Quick Setup Guide or the Online Manu-
al.
3. The LED is blinking blue. Your speaker is in Bluetooth pairing mode. Refer to the Bluetooth pair-
ing directions in either the Quick Setup Guide or the Online Manual.
4. I can't find my Wireless Network (WiFi) listed in the Tivoli App. Make sure your Wireless Ac-
cess Point or Wireless Router is powered on and connected to the internet. Verify that your WiFi
Updating Firmware

Care

Troubleshooting and FAQs

Troubleshooting

English - 19