Installation Procedure - Sanyo SGP-M2 Procedimientos Y Puntos Técnicos Para La Instalación Del Sistema

3. INSTALLATION PROCEDURE

3-1. Anchoring the outdoor unit
Transporting the outdoor unit by hoist:
For hoisting, pass the rope over the hoisting
brackets on the unit vase at 4 locations. (Fig. 14)
Insert wood separators as protective shielding
when using the hoist to prevent the outer casing
from being scratched or deformed by the rope.
Be sure not to touch or apply pressure on tube
connectors. (Fig. 14)
When hoisting with a crane, the crane hook
position must be 1 m or more above the unit.
• Do not lay the outdoor unit on its side during transportation. This can damage
the devices and result in malfunction.
3-2. Preparing and installing the tubing
Material: Phosphorous deoxidized copper seamless tubing (C1220T)
Tube size: Use the correct size according to Table 7.
Table 7
Tube size (mm)
Outer dia.
φ9.52
(C1220 O)
φ12.7
(C1220 O)
φ15.88
(C1220 O)
(C1220 O)
φ19.05
(C1220 1/2,H)
φ22.22
(C1220 1/2,H)
φ25.4
(C1220 1/2,H)
φ28.58
(C1220 1/2,H)
φ31.75
(C1220 1/2,H)
φ38.1
(C1220 1/2,H)
After cutting the tube, be sure to remove all burrs and finish tubing ends to
the correct surface. (The same must be done for branch tubes (purchased
separately).)
When bending tubes, be sure the bend radius is at least 4 times the outer
diameter of the tube.
When cutting or bending tubes, be careful not to cause any pinching or blockage
of the tube.
• Prevent foreign substances such as dirt or water from entering the tube by
sealing the end of the tubes with either a cap or with tape. Otherwise, this can
damage the devices and result in malfunction.
Over 1 m
Rear view
Thickness
T0.8
T0.8
T1.0
T1.2
T1.0
T1.0
Gas tube (wide)
T1.0
Liquid tube (narrow)
T1.0
Branch tube: Purchase separately.
T1.1
T1.35
GB - 13
Rope
Wood shielding
Side view
Tube connectors
Fig. 14
Select tube sizes from Table 2, 3, 5,
and prepare the tubing.
Fig. 15