Dragon Touch DK01 Mini Drone Manual Del Usuario página 10

Infrared obstacle avoidance
Continuously press the Finger button 3 times to activate infrared obstacle
avoidance mode during the flight. The LEDs on the drone will flash 3 times, then
remain on constantly. The drone will fly in another direction when it detects an
obstacle. Continuously press the Finger button 3 times again to exit the mode.
Emergency stop
Press and hold the Power button on the remote for 2 seconds, the drone will stop
flying and fall to the ground. To avoid any unpleasant accidents, please make sure
there is nobody under the drone when using the emergency stop.
Landing
Move your fist to make sure the remote is parallel with the surface during the
flight. Release the Finger button, then press the Power button on the remote to
land.
FLIGHT WITH THE WATERDROP REMOTE CONTROL
Note: Please turn off the standard remote control and gravity sensor remote
control before using the waterdrop remote control.
1. Power on
Place the drone on a flat surface. Press and hold the Power button on the drone
to power on. The LEDs on it will start flashing. You do not need to power on and
pair the waterdrop remote control with the drone.
15
2. Calibrate
Press the Power button on the drone. The LEDs on the drone will start flashing
quickly. The calibration is complete when the LEDs flash slowly.
3. Flight instructions
Take-off
Option 1: Press the button on the waterdrop remote control to commence take-off.
Option 2: Place the drone in the palm of your hand with the head of the drone
facing forwards. Gently throw it into the air.
Note: Please make sure there is enough space while throwing the drone up.
We recommend this option only for skilled drone-users.
16