Flight Operation - Dragon Touch DK01 Mini Drone Manual Del Usuario

3. Charge the gravity sensor remote control.
Charging: red LED Fully charged: green LED
4. Wear the gravity sensor remote control on your palm when fully charged.
5. Purchase 3*AAA 1.5V batteries (not included) and install in the standard
remote control.
MADE IN CHINA
Note: Ensure batteries are installed correctly. DO NOT use old batteries and new
batteries at the same time.
5
5V/1A or 5V/2A
AAA 1.5V
AAA 1.5V
AAA 1.5V
6. The battery of the waterdrop remote control is not rechargeable.
Note:
• For your safety, please use the original battery and USB cables provided.
• The battery life will be reduced when it is used in cold weather.
• Please avoid exposing the battery to sunlight, heat or high temperatures.

FLIGHT OPERATION

Note:
• For each flight, power on the drone first and then power on the remote.
• Please repeat the pairing procedure each time when the drone or remote is
restarted.
• Calibration is a must to avoid losing your drone.
• Flying in the open air and within the control range is highly recommended for
beginners.
FLIGHT WITH THE STANDARD REMOTE CONTROL
1. Power on and pair the remote with the drone
• Place the drone on a flat surface. Press and hold the Power button on the drone
to power on. The drone's LEDs will start flashing.
• Press the Power button on the remote control to power on. Wait for a few
seconds and the pairing will be completed automatically, the LEDs on the drone
will change from white to colorful and solid on.
6