Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. Hot brush high heat setting (210ºC) - airflow not active (red LED light setting)
•
Before use, ensure the hair is clean, dry and tangle-free.
•
For extra protection, apply a heat protection spray.
•
Clip up your hair ready for styling.
•
Turn on the product by sliding up the temperature/speed control button situated in the
middle of the handle and indicating the
indicating the "the hot brush high heat setting (210ºC) with no airflow" setting used for
detangling, styling, smoothing and straightening the hair. Wait for about 1 minute so
the product has reached the default temperature of 210ºC and is ready to style at full
power.
•
Style the hair strand from top to bottom to get the best results.
•
Run the brush through your hair as you would with a traditional brush, starting from
the roots and moving towards the ends in a single movement:
-
In a linear manner for poker straight results
-
With the heated bristle plate and bristles facing towards you or outwards
according to the movement wanted.
•
To turn the product off, simply slide down the temperature/speed control button to the
setting.
•
After use, unplug the product and allow to cool before storing away.
Follow us on www.revamphair.com for the latest hair tips and advice.
Please note:
•
Regular use of styling products may deteriorate the surface coating over time.
•
Do not scratch the surface of the product as this will deteriorate the effectiveness of
the coating.
•
The product reaches a very high temperature during operation, please style with
caution when using. Make sure to keep away from the scalp and skin to avoid burns.
CLEANING & MAINTENANCE
•
Switch the appliance off, unplug from the mains and allow to cool fully before
cleaning.
•
Wipe over all surfaces using a soft damp cloth. Do not use harsh abrasives or cleaners.
•
When the heated brush is completely cool remove any loose hairs from the bristles
after every use and make sure there is no product build up on the ceramic plate or
bristles.
•
Do not immerse the appliance in water or any other liquid.
•
Ensure all parts are dried thoroughly with a soft towel before reusing.
•
To prevent cord damage, do not wrap the cord around the appliance, always store the
cord loosely next to the appliance.
•
Store in a cool dry place.
IMPORTANT SAFEGUARDS
•
This appliance can be used by children aged from 16 years and above. Persons with
reduced physical, sensory or mental capabilities should not use this product. Persons
with lack of experience and knowledge can use the product if they have been
supervised/instructed and understand the hazards involved. Children shall not play
with the appliance. Cleaning and user maintenance shall not be done by children
unless they are older than 16 and supervised. Keep the appliance and cable out of
reach of children under 16 years.
•
WARNING: for additional protection the installation of a residual current device (RCD)
with a rated residual operating current not exceeding 30mA is advisable. Ask an
electrician for advice.
•
Always ensure the voltage to be used corresponds to the voltage stated on the unit
before plugging the appliance into the mains socket.
•
THIS APPLIANCE SHOULD BE UNPLUGGED FROM THE MAIN SUPPLY WHEN NOT IN USE.
•
WARNING: This appliance must not be taken into a bathroom. It should not be used
near bathtubs, basins or any other vessels containing water.
setting. The product light is red coloured
Publicidad
Tabla de contenido
