Millipore NovaSeal NM0029 Manual Del Usuario página 16

16
3. Place the die on a stable, flat surface. The lowest edge of the die should face
away from the tool. Gently squeeze the jaws to open them just enough to ac-
comodate the die. Slide the jaws onto the die. Pull the die locks outward so that
the jaws slide down over the die. Release the locks once the die is in place to
lock the die in position.
4. To remove the die, place the die on a stable, flat surface. Pull the die locks out-
ward while raising the tool so that the jaws slide up over the die.
www.millipore.com