Vetus WC12S2 Instrucciones De Instalación Y Manual De Manejo página 6

Inodoros marinos eléctricos
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
1 Introduction
The Vetus WCS2 and WCL2 toilets are marine toilets with an
integrated pump system. With correct installation and opera-
tion, these toilets function like a normal toilet.
These Vetus toilets may only be used for pumping and
removal of faeces and toilet paper.
These toilet are not suitable for pumping other objects
such as cotton wool pads, tampons, sanitary towels, con-
doms or hair, or for pumping out fluids like oil. This could
cause damage!
Always make sure you have a pair of rubber gloves on board.
2 Operation
The particular cycle chosen is carried out automatically after
operating the appropriate button.
This cycle consists of:
• A flushing phase:
The magnetic valve allows a quantity of water to flow through
for a specified time. This water flows into the toilet bowl.
• A pumping phase:
The motor drives the pump blades. The faeces and toilet
paper are now ground up and pumped out.
• The next phase brings the water level in the bowl back to the
right level.
The magnetic valve allows water through for a specific time.
This water forms a water lock, trapping any smells.
A choice can be made between the 'ECO' cycle of about 10
seconds and the 'NORMAL' cycle that lasts about 20 seconds.
3 Safety
Ensure that the power supply is switched off during mainte-
nance or repairs.
6
110123.01
Note!
4 Installation
4.1 Algemeen
See Page 26 for installation examples.
Always install the toilet in accordance with the applicable regu-
lations of the country concerned. In some areas, it may not be
permitted to pump waste straight from the toilet into the water!
4.2 Fitting the toilet to the floor
Always mount the toilet on a sufficiently strong floor to prevent
the occurrence of point loads and the toilet bowl splitting. If
necessary fit an extra sheet of multiplex under the floor to rein-
force it.
• Place the toilet in the position required.
• Determine the position of the fitting holes. Use the toilet as a
template for this.
• Attach the toilet using the fasteners supplied.
WCS2
WCL2
Electric marine toilets WCS2 - WCL2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wc24s2Wc12l2Wc24l2

Tabla de contenido