Turning On The Instrument And Preparing For Use | 6 - Inficon D-Tek 3 Instrucciones De Operación

INFICON
6 Turning On the Instrument and
Preparing for Use
If the screen does not turn on, the battery is low and needs to be charged. D-TEK 3
can be used while charging.
D-TEK 3 always starts in the last mode that was used.
074-710-P16A D-TEK 3 Operating Manual
1.
Long press the power button (located on the left side of the body of the
instrument) to turn D-TEK 3 On or Off.
ð D-TEK 3 begins a variable-time warm-up for 45 to 90 seconds. When warm-
up is complete, D-TEK 3 is ready to use.
2. To switch modes, press the MODE button. This toggles between Pinpoint and
Manual Zero modes.

Turning On the Instrument and Preparing for Use | 6

13 / 357