Menu Language - LaserLiner 123155 Manual De Instrucciones

4

Menu language

Hold the two arrow buttons down simultane-
ously to access the menu. Now you can use
the arrow buttons to set the required langu-
age; con rm your selection with "MODE".
To exit the language menu, hold down the
"MODE" button for two seconds.
5
Selecting the material
The device features three modes for measuring
moisture, depending on the material in que-
stion. Press the "MODE" button to view the
available types of wood, kinds of construction
material and the index mode (which is inde-
pendent of the material type). Use the arrow
buttons to select the relevant material group
and con rm your selection by pressing the
"MODE" button.
Depending on your selection you will now be
presented with a variety of woods or construc-
tion materials, which can also be selected
using the arrow buttons and con rmed via the
"MODE" button. Complete lists of all these
materials can be found in the tables on the
next page.
Once the material has been selected, the cho-
sen mode will appear at the top of the display
and the corresponding material at the bottom.
The current measured value as a % of the
material moisture can be read from the centre
of the display.
6
Index mode
Index mode is used to rapidly locate moisture
with comparative measurements, without a
direct output of material moisture in %. The
output value (0 through 1000) is an indexed
value that increases as material moisture be-
comes greater. Measurements made in index
mode are independent of material type and
particularly useful with materials for which no
characteristics are stored. When comparative
measurements reveal strongly deviating values,
the course of moisture in the material can be
localized quickly.
MoistureMaster
2 sec
1.
Material: Wood, construction
1.
Material: Index
1.
3.
2.
materials, index
3.
2.
5.
4.
3.
2.
GB
09