Setup Menu - LaserLiner ClimaData Box Manual De Instrucciones

5

Setup menu

Measurement-specific settings on the connected device can be defined in
the Setup menu.
!
New configuration automatically deletes all existing data.
Connected
Sampling rate
Sampling rate
Recording
time
LED cycle setting
10s
Manual
Time lag
on start
Current time
5.1
Sampling rate
The sampling rate defines how often measurements are recorded. Setting
options: 1 ... 60 seconds, 1 ... 60 minutes and 1 ... 24 hours. The maximum
measurement duration is calculated under "Recording time". The measurement
memory is full at the end of this time. See also section 5.6 "Continuous /
non-continuous recording".
5.2
LED cycle setting
Active recording is signalled by the LED (3) and "REC" on the display.
The LED signal can be set to appear every 10, 20 or 30 seconds.
Or the LED signal can be switched off.
Seconds
1 day 21 hrs. 25 min. 0 sec.
20s 30s None
Automatic
Hours
Reset
Reset to factory
settings
ClimaData Box
Alarm setup
Temp alarm low Temp alarm high
RH alarm low RH alarm high
DP alarm low DP alarm high
LED flashes when alarm signals low / high
Alarm when recording is not active
Continuous
recording
Configure Cancel
Save Close Setup menu
settings without saving
Unit
Celsius
Non-continuous
recording
17
EN