Mopar 82211439 Serie Instrucciones De Instalación página 3

This vehicle may be equipped with a "Factory Installed" hood switch harness. This har-
ness will not be visible but will be secured to the factory harness located just inside of the
passenger side fender. If this harness is present, Refer to step "a" in the "Hood Switch
Harness Installation" section below and connect the hood pin switch as described, then
proceed to "Remote Start Antenna Installation" and continue with this instruction
manual. If this vehicle DOES NOT have a factory installed hood switch harness (one is
supplied in the kit), proceed with the complete "Hood Switch Harness Installation" proce-
dure.
Hood Switch Harness Installation
1. Routing of the hood switch harness.
a. Attach the hood switch harness to the hood switch.
b. Route harness along the factory harness secured to
the passenger side fender. Secure the hood switch
harness to existing factory harness with (1) wire tie.
Wire Tie
3 of 9
Factory Harness
Location