Mopar 82211439 Serie Instrucciones De Instalación página 6

5. Connect hood switch harness
gound
a. Remove the 10 mm factory ground
bolt, located at the rear of the pas-
senger side fender.
b. Install the hood switch harness
ground terminal over the 10 mm bolt
and reinstall back into the fender.
WCM Replacement
** Orginal WCM must be removed and the new WCM must be installed **
1. Refer to the vehicle Service Manual section 8 Electrical/
Starting/Remote Start Antenna Module/Installation - for
WCM replacement.
Antenna Installation
1. Refer to the vehicle Service Manual section 8 Electrical/Starting/
Remote Start Antenna Module/Installation - for antenna installation.
10mm Ground Bolt
6 of 9