Cooper BRT6 Instrucciones De Instalación

IB500152EN
Installation Instructions - 6 in. Round Bollard, BRT6
Instructions d'installation - Borne lumineuse arrondie BRT6 de 6 po
Instrucciones de instalación - Bolardo redondo de 6 in (15,24 cm),
BRT6
Risk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of this
product must be performed by a qualified electrician. This product must be installed in accordance
with the applicable installation code by a person familiar with the construction and operation of the
product and hazards involved.
Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or attempting
any maintenance. Disconnect power at fuse or circuit breaker.
Risk of Fire- Refer to product label for specific minimum supply conductor requirements.
Risk of Burn- Disconnect power and allow fixture to cool before handling or servicing.
Risk of Personal Injury- Fixture may become damaged and/or unstable if not installed properly.
Failure to comply with these instructions may result in death, serious bodily injury and property damage.
DISCLAIMER OF LIABILITY: Cooper Lighting Solutions assumes no liability for damages or losses of any kind
that may arise from the improper, careless, or negligent installation, handling or use of this product.
NOTICE: Green ground wire provided in proper location. Do not relocate.
ATTENTION Receiving Department: Note actual fixture description of any shortage or noticeable damage on
delivery receipt. File claim for common carrier (LTL) directly with carrier. Claims for concealed damage must
be filed within 15 days of delivery. All damaged material, complete with original packing must be retained.
Safety: This fixture must be wired in accordance with the National Electrical Code and applicable local
codes and ordinances. Proper grounding is required to insure personal safety. Carefully observe grounding
procedure under installation section.
APPLICATIONS: This lighting fixture is designed for outdoor lighting services, and should not be used in
area of limited ventilation or inside high ambient temperature enclosures. It must be stored in a dry location
prior to installation. Do not expose lighting fixture to rain, dust or other environmental conditions prior to
installation and insertion of photo control or shorting cap (if so equipped). Best results will be obtained if
installed and maintained according to the following recommendations.
WARNING WARNING
Brand Logo
reversed out of
black
INS # INS #