Cooper BRT6 Instrucciones De Instalación página 2

Installation Instructions – 6 in. Round Bollard, BRT6
INSTALLATION
Care must be taken to protect the optical lens from
N ote:
damage.
Tools Required
Ratchet, 5/32" Allen wrench, torque wrench.
Installation
1. Install foundation anchors and conduit(s) using supplied
anchor templates as illustrated. (Figure 1)
1.25"
Max Bolt
Maximum
Projection
conduit projection
of 1" (2X)
Figure 1.
2. Remove bollard from packaging and set aside in a safe
place to prevent scratching or other damage to housing
or lens.
3. Remove base driver assembly by loosening three
screws from bottom of bollard housing. Remove driver
assembly from housing. Set luminaire aside until base
installation is complete.
4. Pull field wires, including ground wire, through conduit.
2
Cooper Lighting Solutions
3/4" Conduit (2X)
Anchor Bolts (4X)
Template
IB500152EN Installation Instructions
5. Assemble a 3/8" hex nut on each of the four (4) anchor
bolts. Place a washer on each hex nut. (Figure 2)
Figure 2.
6. Insert the base driver assembly onto the anchor bolts,
making sure the base driver assembly is sitting on the
washers. (Figure 3)
Figure 3.
Flat Washer (4X)
3/8 Hex Nut (4X)