BabySafe Alaskan Manual De Instrucciones página 22

General
DO NOT install this child restraint under the following conditions:
• Vehicle seats with lap belt.
• Vehicle seats facing sideward or rearward with respect to the running direction
of the vehicle.
• Vehicle seats movable during installation.
This is an i-Size universal ISOFIX enhanced child restraint system. It is approved
according to Regulation 129/02, for use in an i-Size compatible vehicle seating
position. It will fit vehicles with positions approved as ISOFIX positions (as detailed
in the vehicle handbook), depending on the category of the child restraint and of
the fixture. If in doubt, consult either the child restraint manufacturer or vehicle
manufacturer. Read all the instructions in this manual before using this product.
If you have any further questions. If in doubt, please consult the child restraint
manufacturer or the retailer.
The mass group and the ISOFIX size class for which this device is intended is: Group
1, B1 and C; Group 0+, C.
Concerns on Installation
• DO NOT install this child restraint on vehicle seats with Lap Belts and 3-point
Retractor Safety Belt (Fig. 2 & Fig. 3).
• This child restraint is suitable for vehicle seats with ISOFIX anchor points with
the Base (Fig. 4).
• DO NOT install this child restraint on vehicle seats that face sideways or rearward
with respect to the moving direction of the vehicle (Fig. 5.1).
• DO NOT place rear-facing child restraint on front seat with air bag (Fig. 5.2), death
or serious injury may occur. Please reference vehicle owner's manual for more
information.
• It is recommended to install this child restraint on the rear vehicle seat, facing
rearwards (Fig. 5.3).
22