Using the Child Restraint - Rearward Facing Mode - for Child under 18 kg /
Newborn - 4 years old, 40–105 cm
Reference age: Newborn to 4 years old
Recline position: Position 1
• There is only reclined position and without upright position when installing for
children weighting 0-13 kg.
• Please install the child restraint on the vehicle seat, then put the child in it.
Squeeze child restraint rotate release button (Fig. 25), turn the child restraint to
backward position (Fig. 26-27), and you can hear a „click-sound".
NOTE
• We recommend using the full inner pads while the baby is 0–6 months or until
they outgrow the pads. The inner pads increase side impact protection (Fig. 14).
• After the child is placed into the seat, check whether the shoulder harnesses are
at proper height.
Securing your Child in the Child Restraint Rearward Facing
1. Push down the webbing adjuster button (Fig. 15.1), while pulling out the
shoulder harnesses to the proper length (Fig. 15).
2. Press the red button to disengage the buckle (Fig. 16).
3. If necessary, place the small child inner pads in the child restraint and thread
the shoulder harnesses, waist harnesses.
4. Leave the harnesses on the left side and right side respectively (Fig. 17).
5. Place the child into the child restraint and pass both arms through the
harnesses (Fig. 18).
NOTE: After the child is seated, recheck whether the shoulder harnesses are at
the proper height.
6. Engage the buckle (Fig. 19).
7. Pull down the adjustment webbing and adjust it to the proper length to make
sure your child is snugly secured (Fig. 20).
NOTE: Make sure the space between the child and the shoulder harness is
about the thickness of one hand (Fig. 20).
24