CARE AND CLEANING
OVEN RACKS
The rack that was provided with your oven may remain in
the oven during the steam-cleaning cycle without being
damaged.
OVEN DOORS
Lift-Off Oven Door
The door is very heavy. Be careful when removing and
lifting the door.
Do not lift the door by the handle.
To remove the door:
1. Fully open the door.
2. Pull the hinge locks down toward the door frame, to
the unlocked position. A tool, such as a small flat-blade
screwdriver, may be required.
Slot
Hinge lock
Pull hinge locks down to unlock
3. Firmly grasp both sides of the door at the top.
4. Close door to the door removal position. The door
should be open approximately 3" with no obstruction
above the door.
Removal position
5. Lift door up and out until both hinge arms are clear of
the slots.
49-2000696 Rev.0
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. Starting on the left side, with the door at the same
angle as the removal position, seat the indentation of
the hinge arm into the bottom edge of the hinge slot.
The notch in the hinge arm must be fully seated into the
bottom of the slot. Repeat for right side.
Bottom
edge of slot
Indentation
3. Fully open the door. If the door will not fully open, the
indentation is not seated correctly in the bottom edge of
the slot.
4. Push the hinge locks up against the front frame of the
oven cavity, to the locked position.
Hinge
arm
Hinge
lock
Push hinge locks up to lock
5. Close the oven door.
Hinge arm
21