Setting Notification Sound - Kenwood TH-D74A Manual Del Usuario

Transmitting a Message
1 Press [MSG].
The message list appears on the display.
2 Press [MENU].
The message list Menu appears on the display.
3 Select [Reply], [Edit], or [New].
• When selecting [Edit], the original message is quoted
and you can edit it.
• Enter the Callsign when selecting [New].
4 Enter the message
Key Name
[ENC]/ [ ]/[ ] To select a character.
To move the cursor backward.
[ ]
To move the cursor forward.
[ ]
[A/B] To delete the message on the cursor.
Note:
◆ When using the already registered user phrases, refer to the
following step 5.
5 Enter the user phrase.
Press [F] to enter the message compilation mode.
You can select the user phrase among the already
registered user phrases by Menu No.560.
6 Select [Send] and press [A/B] to send the message.
You can select the following items other than [Send],
[Reply], [Edit], and [New] in message list Menu.
[Re-TX]: Send the message again.
[Position]: Search position information from a position list.
Operation
[POS Request]: The position data of the transmitting
station is displayed (if the station data is available).
[Unread]: Change the existing reading message to unread
message.
Storing User Phrases
This function (clipboard image) allows you to paste phrases
into the APRS message compilation mode. You can create
up to 20 phrases each of which can consist of up to 32
characters.
1 Access Menu No. 560.
You can select from user phrase 1 to user phrase 20.
2 Press [ENT].
3 Store user phrase.
4 Press [ENT].
Note:
◆ The user phrase function can only be used in the message
compilation mode.
◆ Before a message is copied, the number of letters cannot be
guaranteed. Only the number of letters available will be copied,
and the remainder will be truncated.

SETTING NOTIFICATION SOUND

RX Beep Type
This transceiver beeps each time it receives any type of
APRS packets.
1 Access Menu No. 570.
2 Select [Off], [Message Only], [Mine], [All New], or [All].
[Off]: The APRS beep tone does not sound.
[Message Only]: Beep sounds only when a message is
received at your station address.
[Mine]: Beep sounds when a message is received at your
station address and your transmitted data is received by a
digipeater.
[All New]: Beep sounds when a message is received at
your station address and new packet data is received.
[All]: Beep sounds when a message is received at your
station address and duplicate data or invalid data is
received.
®
APRS
33