Mopar XBM Manual Del Usuario página 28

28
2. With the wiTECH diagnostic application, perform the following steps:
• Select "WIRELESS CONTROL MODULE (WCM)"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight "PROGRAMMING IGNITION KEYS OR KEY FOBS"
• Select "NEXT"
• Enter the PIN when prompted.
• Select "NEXT"
• Verify that the PIN number is correct
• Once verified select "NEXT"
• Note On­Screen instructions and select the "FINISH" button
• Cycle ignition key after the successful routine completion.
NOTE: If the original keys do not successfully program to the new WIN after the proper procedures are followed
correctly, programming new keys will be necessary.
NOTE: A maximum of eight keys can be learned by the WIN. Once a key is learned by a WIN, that key has ac­
quired the Secret Key for that WIN and cannot be transferred to any other vehicle.
ECU RESET
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
CAUTION: Read all notes and cautions for programming procedures.
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select "WIRELESS CONTROL MODULE (WCM)"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight "RESET ECU"
• Note On­Screen instructions and select the "NEXT" button
• Select "FINISH"
PEM MODULE PROGRAMMING
NOTE: Perform this procedure on vehicles equipped with "Key N Go" push button ignition.
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
CAUTION: Read all notes and cautions for programming procedures.
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select the "PASSIVE ENTRY MODULE"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight "PEM REPLACED"
WINDOW CALIBRATION
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
NOTE: Vehicles equipped with the auto up feature must have the windows calibrated after a battery disconnect.
NOTE: The door must be completely closed when starting this step.
1. Sit in the driver seat and close the door.
2. Lower the window part of the way down.
3. Run the window to the full up position and continue to hold the switch for an additional two seconds.
4. Run the window to the full down position and continue to hold the switch for an additional two seconds.
5. Raise the window to the full up position.
6. Repeat the steps for the remaining windows.
UPDATE PRESSURE THRESHOLDS
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
NOTE: The vehicle must be driven before the TPMS light will turn off.
4280416
Jul 01, 2011 K6861201