Axis P12 Serie Guia De Instalacion página 25

How to Install AXIS P1214-E Sensor Unit
The AXIS P1214-E can be mounted like the AXIS P1214/AXIS P1224-EE, see page 23.
The AXIS P1214-E can also be mounted in the supplied outdoor housing. The cables can be routed
through the wall directly into the housing, or through one of the punch-outs in the cover.
1. Remove the two screws and the bracket.
2. Insert the camera into the ball joint and fasten with the stop screw.
3. Drill a hole through the wall or remove one of the punch-outs in the cover.
4. Fasten the plate to the wall using screws and plugs appropriate for the wall material.
Ensure that the camera bracket is pointing towards the area to be monitored. If routing
the cable through the wall, align the cut-out in the plate with the hole in the wall.
5. Place the ball in the socket and fasten the bracket with the screws. Aim the camera
away from the wall before tightening the screws. Position the camera so that the flat
surface on the thread is vertical or horizontal.
6. Route the cable through the wall, or through the punch-out in the cover.
7. Attach the cover.
8. Proceed to Connect the cables, see Connect the Cables on page 26.
AXIS P12 Network Camera Series
25
EN