Setup Instruction - Bestway 53302 Instrucciones De Instalación Y Funcionamiento

Keep Unit Grounded: air blower should be grounded. In the event of an electrical short
circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric
current. This product is equipped with a cord having a grounding wire with an appropriate
grounding plug. The plug must be plugged into an outlet that is properly installed and grounded
in accordance with all local codes and ordinances.
Warning: Improper installation of the grounding plug is able to result in a risk of electric shock.
When repair or replacement of the cord or plug is required, do not connect the grounding wire to
either flat blade terminal.
The wire with insulation having an outer surface that is green with or without yellow stripes is the
grounding wire.
CAUTION: Check with a qualified electrician or serviceman when the grounding instructions are
not completely understood, or when in doubt as to whether the air blower is properly grounded.
Do not modify the plug provided. If it will not fit the outlet, have the proper outlet installed by
a qualified electrician. The appliance must be positioned so that the plug is accessible. If the
supply cord is damaged, it must be replaced by the manufacture or its service agent or a similarly
qualified person in order to avoid a hazard.
GFCI Test
A. To test the GFCI plug, insert it into a grounding type receptacle.
B. Press the "RESET" button; the indicator turns red.
NOTE:
If the indicator light is not on, the test has failed.
C. Press the "TEST" button. The indicator turns off.
NOTE:
If the indicator light is not off, the test has failed.
D. Press the "RESET" button, the indicator light turns red, and the blower is ready for use.
WARNING:
Risk of electric shock. The GFCI must be tested before each use.
WARNING:
Do not use the blower if the above test fails. Please contact your local Bestway Customer Service.

Setup Instruction

Placement:
Use on a flat, grassy area only. Do not use on pavement or hard surfaces. Usage area should be free of rocks, bumps, holes, sticks,
etc. The water park setup location should have a minimum distance of 10ft (305cm) from any free-standing structures or obstructions.
this include: houses, garages, fences, trees, playground equipment, large rocks, etc.
10ft.(305cm)
safety area
303021192640_53302/53304/53306_14x21cm
10ft.(305cm)
3
/ 英
GROUNDING METHODS
Sketch A
Grounded
Outlet
Grounding Pin
ON/OFF SWITCH
OFF — O
ON — l