Vacuum Cleaning - Philips City Line FC8426/03 Manual De Instrucciones

3 Push the rocker switch again to make the brush strip disappear into the convertible nozzle
housing (fig. 7).
Reach & Clean nozzle (specific types only)
The Reach & Clean nozzle can be used on either carpets or hard floors.The nozzle can be
turned 360 degrees to 4 different positions, allowing you to also vacuum clean hard-to-reach
places in an easy way.When the nozzle is positioned lengthwise, the suction power is
concentrated at the front side of the nozzle (fig. 8).
To adjust the nozzle to the type of floor and the area to be cleaned, put your foot on the
indicated spot and then turn the tube until the nozzle is in the required position (fig. 9).
1 With the nozzle positioned breadthwise and the brush strip folded out, you can clean large
hard floor areas.Turn the tube until the brush strip pops out of the nozzle housing and the
nozzle is positioned breadthwise (fig. 10).
2 With the nozzle positioned lengthwise and the brush strip folded out, you can vacuum clean
small hard floor areas.Turn the tube 90 degrees anti-clockwise until it is positioned
lengthwise with the brush strip still folded out of the nozzle housing (fig. 11).
3 With the nozzle positioned breadthwise and the brush strip folded in, you can vacuum clean
large soft floor areas.Turn the tube 90 degrees anti-clockwise again to position the nozzle
breadthwise and to make the brush strip disappear into the nozzle housing (fig. 12).
4 With the nozzle positioned lengthwise and the brush strip folded in, you can vacuum clean
small soft floor areas.Turn the tube 90 degrees anti-clockwise again until it is positioned
lengthwise with the brush strip still folded in (fig. 13).
Crevice tool, small nozzle and small brush (specific types only)
1 Connect the crevice tool, small nozzle or small brush directly to the handgrip or to the tube.
The crevice tool can be used either for cleaning narrow corners or hard-to-reach places.
The small nozzle can be used for vacuum cleaning small areas, e.g. the seats of chairs and sofas.
The small brush can be used for cleaning computers, bookshelves etc.
Accessory clip (specific types only)
The accessory clip can simply be snapped onto the tube.
The crevice tool and the small nozzle can be snapped onto the clip (fig. 14).

Vacuum cleaning

1 Pull the cord out of the appliance and put the mains plug in the wall socket (fig. 15).
2 Switch the appliance on by pushing the on/off button on top of the appliance with your foot.
3 The appliance can be carried in two ways:
You can carry the vacuum cleaner vertically by picking it up by the handle on the front of the
appliance (fig. 16).
You can carry the vacuum cleaner horizontally by lifting it by the handle on top of the
appliance.
Adjusting suction power
You can adjust the suction power while vacuum cleaning.
1 Adjust the suction power by means of the electronic suction power control knob (fig. 17).
2 Turn the knob to MAX for maximum suction power (fig. 18).
ENGLISH 7