Connections - Axxess AXGMMT-02 Instrucciones De Instalación

From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
Note: If installing an AXSWC (sold separately), there will be an accessory wire there to
connect as well.
• Connect the Blue/White wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
• If also installing an AXSWC (sold separately), connect the Brown wire to the Brown wire in
the 12-pin pre-wired AXSWC harness.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
2

CONNECTIONS

From the AXGMMT-02 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Brown wire to the Brown wire from the 16-pin harness with stripped leads.
• Disregard the Red wire, it will not be used in this application.
• Disregard the Red & White RCA jacks, they will not be used in this application.
12-pin pre-wired AXSWC harness:
This harness is to be used along with the AXSWC (sold separately) to retain steering wheel
audio controls. If the AXSWC is not being used, disregard this harness. If it will be used,
please refer to the AXSWC instructions for radio connections and programming. Disregard
the harness that comes with the AXSWC.
(Figure A)
• Connect the Red wire to the
Green/Black wire
accessory wire.
• Connect the Green/Black
wire, to the Green/Black
wire in the 10-pin Black
connector located in the
steering column. (Figure A)
Continued on the next page