Tabla de contenido
Publicidad
Section 1 - Product Overview
1
2
3
1
Sync Button
2
Status LED
3
Speaker
4
Built-in Microphone
5
2 Megapixel Lens
6
Light Sensor
7
PIR Detector Window
8
Micro-USB Port
D-Link DCS-2802KT User Manual
Hardware Overview
Camera
Front
Press to start syncing the camera to the hub. Press to power on the camera from factory off state.
See Camera LED Behavior on page 4.
Speaker for the two-way audio feature.
Listens to the environment.
1080p resolution.
Senses light to determine if night mode should be enabled.
The PIR motion detector is behind this window. Senses motion to trigger recordings.
Peel back the water-resistant cover and plug the supplied power connector here to charge the
camera's battery. Note: Please only plug in the camera in a dry location.
4
5
6
7
Back
8
3
Publicidad
Tabla de contenido
