Load And Unload Discs; Load The Discs; Unload The Discs; Reset The Autoprinter - Rimage AutoPrinter Guia Del Usuario

Operate the AutoPrinter

Load and Unload Discs

You can load up to 100 discs per carousel bin. You may load discs in the bins
before installing the carousel.
When the carousel is installed in the AutoPrinter, discs can be installed one
bin at a time by using the following procedure
Tip: Use carousel bins 1, 2, and 3 to load blank discs. Bin 4 is used only for
outputting completed discs.

Load the Discs

Important! When you rotate the carousel to load discs, the AutoPrinter
pauses. After loading discs in the carousel, you must prompt the AutoPrinter
to resume operation. Refer to step 4.
1. Press the operator button to rotate the carousel and place a bin 1, 2,
and 3 in position to load discs. The AutoPrinter pauses, allowing you to
load discs. The active indicator light blinks.
2. Place blank discs in the bin.
Important! Place the discs into the bin with the recording side facing down
Tip: Hold the discs by the outer edge so you do not put fingerprints on
either the top or the bottom surface of the discs. Fingerprints on the top
of a disc can affect printing quality. Rimage recommends wearing lint free
gloves.
3. Repeat steps 1–2 until the bins 1, 2, and 3 are filled.
4. Press and hold the operator button for two blinks of the carousel
indicator light. The AutoPrinter resumes operation, using the input/
output bin combination that was in place when the AutoPrinter was
paused.
5. If necessary, reset the AutoPrinter. Refer to the
section.
2001809_A
All manuals and user guides at all-guides.com

Reset the AutoPrinter

For more information visit

Unload the Discs

Important! When you rotate the carousel to unload discs, the AutoPrinter
pauses. After unloading discs from the carousel, you must prompt the
AutoPrinter to resume operation. Refer to step 4
1. Press the operator button to rotate the carousel and place a bin in a
position to unload discs. The AutoPrinter pauses, allowing you to unload
discs. The active indicator light blinks.
2. Remove the discs from the bin.
3. Repeat steps 1–2 until the desired bins are empty.
4. Press and hold the operator button for two blinks of the carousel
indicator light. The AutoPrinter resumes operation, using the input/
output bin combination that was in place when the AutoPrinter was
paused.
5. If necessary, reset the AutoPrinter. Refer to the
section.
Reset the AutoPrinter
By default, the AutoPrinter is set to use bins 1, 2, and 3 as the input bins,
and bin 4 as the output bin.
Tip: The AutoPrinter begins to picks discs from bin 3. When bin 3 is empty,
the AutoPrinter picks discs from bin 2. When bin 2 is empty, the AutoPrinter
picks discs from bin 1. The AutoPrinter continues to pick discs in this
configuration until all discs have been printed, or the bin configuration is
changed.
If the default bin configuration is changed and the AutoPrinter needs to be
reset, the active indicator light will blink 4 times per second. To reset the
AutoPrinter, press and hold the operator button for 3 blinks of the carousel
indicator light.
Tip: The AutoPrinter can be reset to the default bin configuration at any
time.

Set Printing Preferences

Printing preferences allow you to set up your AutoPrinter to produce the
best possible labels on your discs. Refer to your Everest or Prism printer user
guide for specific printing preferences instructions.
rimage.com/support
Reset the AutoPrinter
9