Dehumidifying Mode; Setting The Timer; Fan Mode - DeLonghi PAC EM Serie Manual De Instrucciones

The most suitable temperatures during the summer range from 24
to 27°C. However, setting the temperature significantly lower than
the outdoor temperature is not recommended.
SILENT FUNCTION (
only and on some models only)
By activating this function in air conditioning mode, the noise of
the appliance is further reduced.
To activate it, press the button

DEHUMIDIFYING MODE

This is ideal for reducing humidity in the room (spring and au-
tumn, damp rooms, rainy periods, etc). For this type of use, the
appliance must be set up as for air conditioning mode. That is, the
air exhaust hose (B1) must be fitted to the appliance to allow the
humidity to be discharged outside.
To correctly set this mode:
• Press repeatedly the MODE key (C2) until the dehumidify-
ing indicator (C12) appears.
• The appliance will automatically choose the best air flow.
Note: in case of high ambient humidity, it is possible to drain the
condensate continuously by applying the hose supplied (B5) to
the upper drainage hose (A10) and thus allowing the water to
flow into a container. Pay attention the water does not overflow
onto the floor and the drainage tube is not obstructed (Fig. 9).

FAN MODE

When using this mode, the air exhaust hose (B1) does not need
to be attached to the appliance.
To correctly set this mode:
available in conditioning mode
(C6), the indicator (C9) turns on.
• Press repeatedly the MODE (C2) key until the fan indicator
lights on.
• Pressing repeatedly the
flow is selected.
The available air flows are:
Minimum air flow: when most silent operation is de-
sired.
Medium air flow: when the noise level needs to be low
but with a good comfort level.
Maximum air flow: for maximum performance.
SELECT THE TEMPERATURE SCALE
The temperature can be displayed in °C or °F. To change the tem-
perature unit of measure select the air conditioning mode then
press both the decrease
about 3 sec.

SETTING THE TIMER

The timer allows the delayed start up or shut down of the appli-
ance. This function will prevent wasting electricity by optimising
the operating periods.
How to program delayed shut down
• While the appliance is on in any operating mode, delayed
shut down can be programmed.
• Press the Timer button (C7): the timer indicator (C10) and
hours light up.
• Use buttons (C3) or
until the appliance should shut down.
A few seconds after the timer is set, the setting is acquired, the
display shows the operating mode and the timer indicator stays
lit. At the pre-set time, the air conditioner goes into Standby.
To cancel the timer program, press the timer button (C7) twice.
The timer indicator (C10) will go off.
How to program delayed start up
• Set the appliance to standby.
• Press the timer button (C7): the timer symbol (C10) and
hours light up.
• Use buttons (C3) or
after which the appliance should start to operate.
• The appliance will start to operate in the same operating
14
(C5) key till the desired air
(C3) and increase (C4) keys for
(C4) to set the number of hours
(C4) to set the numbers of hours