POWER SMITH MLJS12C Manual Del Operador página 6

SPECiFiC SAFETY RULES FOR CORDLESS JiG SAWS
WARNiNG:
DO NOT let comfort or familiarity with this tool (gained from
repeated use) replace strict adherence to safety rules. if you use this tool unsafely
or incorrectly, you can suffer serious personal injury!
WARNiNG:
Hold tool by insulated gripping surfaces when performing an
operation where cutting tools may contact hidden wiring or its own cord. Contact
with a "live" wire will make exposed metal parts of the tool "live" and shock the
operator!
• Avoid cutting nails,
• Do not cut hollow pipe.
• Check for the proper clearance
blade will not strike the floor, work bench, and etc
• Make sure the blade is NOT contacting the work piece
is turned on.
• Do not leave the tool running.
• Do not touch the blade or the work piece immediately after operation;
it may be extremely hot and could burn your skin.
• Always switch off and wait for the blade to come to a complete stop
before removing from the work piece.
• Keep hands away from the moving parts.
• Some material contains chemicals which may be toxic.
prevent dust inhalation and skin contact. Follow material supplier safety data.
• Be aware that this tool is always in an operating condition,
does not have to be plugged into an electrical outlet.
• Always hold the tool firmly in your hands
• Wear eye and hearing protection.
Unless otherwise specified, everyday glasses provide only limited impact resistance, they are not
safety glasses. Use only certified safety equipment; eye protection equipment should comply with
ANSI z87.1 standards. Protective hearing equipment should comply with ANSI s3.19 standards.
• Protect your lungs.
will reduce the risk of personal injury.
• Always disconnect battery pack from tool
or off position before any assembly, adjustments or changing of accessories. Following this
instruction will reduce the risk of serious personal injury.
• Do not place battery tools or their batteries near fire or heat.
reduce the risk of explosion and possibly personal injury.
• Never use a battery which has been dropped or received a sharp
blow.
A damaged battery is subject to explosion. Properly dispose of a dropped or damaged
battery immediately.
English
All manuals and user guides at all-guides.com
inspect work piece for any nails and remove them before operation.
beyond the work piece before cutting so that the
.
Operate the tool only when hand-held.
Always use safety glasses with side shields.
Wear a face or dust mask if the operation is dusty. Following this rule
6
before the switch
Take caution to
because it
before switching the tool "ON".
or place the switch in the locked
This will