®
Helios 2
TM
4 Light - 120 Volt Lighting Controller
Easy Guide
VANCOUVER, W ASHINGTON U.S.A.
Instructions for Use
1. Please consult with a licensed electrician prior to instal-
lation of the Helios 2. High voltage can be dangerous!
2. Connect 120 volt power to the 3 screws under the pro-
tective cover. (See 'Instructions for Operation' section).
3. Replace protective cover with screws provided.
4. Securely mount your Helios 2, with hardware provided,
near the ballasts to be operated. It should be placed
away from water, mist, spray, etc.
5. Plug your ballasts into the outlets on the left and right
side of the controller.
6. Plug the relay activation cord set into Apollo
Series wall timer.
7. Turn on Helios 2 power switch to activate
lighting controller.
8. Your Helios 2 will now control your ballasts at the
desired settings until the power is defeated.
Controlling a light bank
Sun System
R
to 120 Volt Ballast
to 120 Volt Ballast
Sun System
R
www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.
Controller Specifications
Size: 11"H x 11"W x 4"D
Weight: 4 lbs.
Voltage Input: 120 volts
Voltage Output: 120 volts
Maximum Amperage: 50 amps
Maximum Wattage: 4000 Watts
Hertz: 60 Hz
Time switch: 120 Volt relay trigger cord set
Operating Temperature: 40o to 125o F | 5o to 52o C
Storage Temperature: 32o to 135o F | 0o to 57o C
to 120 Volt
Timed Outlet
Fan
to 120 Volt Ballast
Helios 2
120 Volt
to 120 Volt Ballast
to 50 Amp
Power Source
to 120 Volt
Titan Apollo
Timer
24 HR
Timer
®
Wiring
diagram
Sun System
R
Sun System
R
120 Volt
Hot
Ground Neutral