urmet domus SOFT TOUCH 1039/13 Manual Del Usario página 5

PERFoRMaNcE
The features of the touch IP calling module are:
• Signal management using 3.5" graphic colour display and evolved GUI.
• Simultaneous lock with pulse capacitance discharge (SE+; SE-) and no-voltage contact relay (C-NC-NO)
operation.
• Garage gate lock low current operation (SE2).
• Hall button input.
• Door sensor input.
• Audio repeat device control for use with hearing aid.
• LAN connection with RJ45 connector and POE power.
• 2 terminals for local power supply.
• 125kHz integrated transponder key reader (Ref. 1125/50).
• Infrared proximity sensor for user detection.
• CCD colour camera with wide-angle lens.
• Alphanumeric keypad with 18 buttons, three of which multifunctional.
iNSTaLLaTioN
• Arrange wire conduits in order that they end in the lower holes of the flush mounting box.
• Fix the flush mounting box Ref. 1145/53 at the height shown.
• Fix the magnet (tamper) at the indicated height with the two-sided adhesive tape included
• Make electric connections.
• Fix the call module to the flush mounting box.
• Fix the front panel to the call module.
( * ) 1,40 m from the floor is the measure to be respected according to Directive for disabled people (for
example, in France these normes are included in Law 2005-102 of 11/02/2005, in Decree 2006-555 of
17/05/2006 and following amendments of 1/08/2006, 26/02/2007 and 21/03/2007).
DS1039-06B
TAMPER
§
The highlighted part of the magnet must face
the wall of the box (in contact with the two-
sided adhesive tape).
ENGLiSh
5