Airspa Assembly Instructions - LAZBOY Air Spa Instrucciones De Operación

AirSpa ® 10-Motor Massage & Heat Recliner
Assembly Instructions:
WARNING
– To reduce the risk of injur y:
• Do not operate the unit until the back is installed and locked.
1. Install the back.
• Lay the back across the chair arms. Lift the back at a slight angle and align
the brackets on the back with the brackets on the body (F
• Lower the back onto the body, making sure the back and body brackets are
completely engaged.
• To make sure the back is properly installed, with both sets of back
and body brackets engaged, stand behind the chair and twist the
back from side to side. If one or both sides move out of position
the brackets are not engaged (F
repeat the steps above.
• If you are unable to install the back properly contact your La-Z-Boy
dealer for assistance.
• Lock the brackets by using a screwdriver to push down the locking levers (F
NOTICE:
Do not plug the transformer in until instructed.
2. Locate the massage connectors.
• Stand at the side of the chair and push the back rearward to recline the
seat and back.
• Gently roll the chair forward to rest on its arms and the top of the back,
revealing the underside of the chair and the connectors.
3. Identify the three connections you will make.
• Locate the five wires with connectors. Four wires are located next to the
rear body rail. One wire is located next to the body side panel; if the chair
has an arm storage compartment it is located on the right side and if the
chair has an arm storage pocket it is located on the left side.
• The two square connectors are the Vibrating Motor connectors (F
• The one small round connector is the Power Transformer connector (F
• The two large round connectors with white dots are the Hand Wand
connectors (F 4).
IGURE
4. Connect the Vibrating Motors.
• Align the two square Vibrating Motor connectors and push the connectors
together until they lock (F
IGURE
5. Connect the Hand Wand.
• Align the white dots on the Hand Wand connectors and push the connectors
tightly together (F 5).
IGURE
(Assembly Instructions Continued)
6
1).
IGURE
2). Remove the back and
IGURE
IGURE
5).
AirSpa
F 1
IGURE
Body
Bracket
Back Bracket
®
3).
IGURE
F 3
IGURE
Back
Bracket
4).
4).
IGURE
® 10-Motor Massage & Heat Recliner
Assembly Details:
F
IGURE
Back and body brackets on this
side are not engaged. Remove
the back and reinstall.
F
IGURE
Locking
Lever
Locked
Position
F 5
IGURE
Vibrating Motor
Connectors
Hand Wand
Connectors
Power Transformer Connector
2
4
Vibrating Motor
Connectors
Hand Wand
Connectors
Power Transformer
Connector
7