La-Z-Touch 2-Motor Massage & Heat Recliner Assembly Instructions - LAZBOY La-Z-Touch Instrucciones De Operación

La-Z-Touch 2-Motor Massage & Heat Recliner
®
Assembly Instructions:
WARNING
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
NOTICE:
Do not plug the transformer in until instructed.
1. The power transformer is secured to the seat swing. Carefully cut the cable tie and set
the power transformer aside.
2. Install the back.
Lay the back across the chair arms. Lift the back at a slight angle and align the brackets
•
on the back with the brackets on the body (F
Lower the back onto the body, making sure the back and body brackets are completely engaged.
•
- To make sure the back is properly installed, with both sets of back and body brackets
engaged, stand behind the chair and twist the back from side to side. If one or both sides
move out of position, the brackets are not engaged (F
repeat the steps above.
- If you are unable to install the back properly, contact your La-Z-Boy dealer for assistance.
Lock the brackets by using a screwdriver to push down the locking levers (F
•
3. To access the connectors, gently roll the chair forward to rest on the arms and the top of
the back. The connectors are located at the back of the chair, under the rear seat (F
4. Identify the three electrical connectors.
The two larger, round connectors are for the hand wand connection (F
•
The smaller, round connector is for the power transformer connection (F
•
(Assembly Instructions Continued)
6
1).
IGURE
2). Remove the back and
IGURE
3).
IGURE
IGURE
5).
IGURE
5).
IGURE
La-Z-Touch 2-Motor Massage & Heat Recliner
®
Assembly Instructions:
F 1
IGURE
Body
Bracket
Back Bracket
F 3
IGURE
4).
Back
Bracket
F 5
IGURE
Hand Wand Power Transformer
Connectors Connector
F 2
IGURE
Back and body brackets on this side
are not engaged. Remove the back
and reinstall.
F 4
IGURE
Outside Back
Locking
Lever
Locking
Position
Left Side (Sitting) Rear Seat
7