Thermo-Electric Cooler Recliner With 2-Motor; Massage & Heat Assembly Instructions - LAZBOY La-Z-Touch Instrucciones De Operación

Thermo-Electric Cooler Recliner with 2-Motor

Massage & Heat Assembly Instructions:
WARNING
- - To reduce the risk of injur y:
• Do not operate the unit until the back is installed and locked.
NOTICE:
Do not plug in until instructed.
1. Install the back.
• Lay the back across the chair arms. Lift the back at a slight angle and align
the brackets on the back with the brackets on the body (F
• Lower the back onto the body, making sure the back and body brackets are
completely engaged.
• To make sure the back is properly installed, with both sets of back
and body brackets engaged, stand behind the chair and twist the
back from side to side. If one or both sides move out of position,
the brackets are not engaged (F
repeat the steps above.
• If you are unable to install the back properly, contact your La-Z-Boy
dealer for assistance.
• Lock the brackets by using a screwdriver to push down the locking levers (F
2. The thermo-electric cooler power transformer, 2-motor massage and heat power
transformer and rubber mat are stored inside the cooler during shipping. Remove
the power transformers from the cooler and unwind the cords.
NOTICE:
- - To reduce the risk of product damage:
• Before operating, remove the white packing material located under
the cooler, inside the arm cavity.
3. Packing material is used under the thermo-electric cooler to protect and support
the cooler during shipping. The packing material must be removed before operating
the cooler to prevent damage. Lift the thermo-electric cooler from the chair arm
and set in the seat (F 4). Remove the white packing material from inside the
IGURE
arm cavity (F 5).
IGURE
4. Carefully lower the thermo-electric cooler into the chair arm, making sure the
power connector is toward the back of the chair (F
5. To access the massage connectors, stand at the side of the chair and push
the back rearward to recline the seat and back. Hold the top arm closed to
prevent the cooler from falling out, and gently tip the chair forward to rest
on its arms and the top of the back.
(Assembly Instructions Continued)
6
1).
IGURE
2). Remove the back and
IGURE
®
3).
IGURE
6).
IGURE
Thermo-Electric Cooler Recliner with 2-Motor
Massage & Heat Assembly Instructions:
F 1
IGURE
Body
Bracket
Back Bracket
F 3
IGURE
Back
Locking
Bracket
Lever
Locked
Position
F 5
IGURE
White Packing
Material
F 2
IGURE
Back and body brackets on this
side are not engaged. Remove
the back and reinstall.
F 4
IGURE
F 6
IGURE
Chair
Back
Thermo-Electric Cooler
Power Connector
7