BIG ASS FANS HAIKU Guia De Instalacion página 10

Install Light
5
WARNING: Skin or eye damage may result from directly viewing ultraviolet light produced by the lamp in this apparatus. Always
disconnect power before relamping or servicing. Replace ultraviolet LEDs with Model No. 1050-39-30, manufactured by Big Ass Fans.
Slide the light down the extension tube, resting it on the fan hub. Orient the light so that the tab at the top of the light rests in the groove
at the top of the motor bracket (Fig. 5.1). Be careful not to scratch the extension tube while positioning the light. Connect the wiring
harness on the light to the receptacle from the motor hub. Tighten the set screw at the top of the light (Fig. 5.2).
Fig. 5.1
Tab
Motor Bracket
8
Light
Fig. 5.2
Set Screw
Wiring
Harness
Light Kit Weight:
1 lb (454 g)
HAIKU® BY BIG ASS FANS | REV. D | 10/12/2020