Connecting Power To The Monitor / Charging Battery; Connecting Power To The Camera - Levana Jena Manual Del Usuario

SETUP

Connecting Power to the Monitor / Charging Battery

1. Connect the power adapter attached to the charging dock marked MONITOR
into an available wall outlet. For safety reasons, ONLY use the adapters included in
the package.
2. With the battery in the monitor, place the monitor into the charging dock with the
screen facing you.
3. Press and hold the POWER
the monitor ON.
4. The icon in the top right corner of the main screen will show you the battery power status.
EMPTY

Connecting Power to the Camera

1. Take the second power adapter and connect the small end of the power adapter marked
CAMERA into the DC input on the side of the camera base as shown in the diagram. For
safety reasons, ONLY use the adapters included in the package.
2. On the side of the camera, slide the POWER switch
The POWER LED will light up.
Note: Baby monitors and cameras with power cords should never be hung on or near the crib as it is a strangulation
hazard. Power cords should be kept no less than 3 feet away from the crib and the baby's reach at all times.
button on the side of the monitor to turn
CHARGING FULL
Note: When monitor battery is low, POWER LED will
flash slowly & beep. Recharging the battery will be
required shortly after.
LEFT to the ON position.
10