Filter Maintenance - Uline H-5048 Manual Del Usuario

INTERCEPT® MICRO FILTER AND MICRO
CLOTH FILTER
1. Empty and inspect the Intercept® Micro Filter every
time you start and finish vacuuming. (See Figure 18)
Figure 18
2. Replace if necessary. A clogged and dirty filter
restricts airflow and results in reduced suction and
overheating.
3. To replace the Intercept® Micro Filter, slide filter into
the micro cloth filter and secure into vacuum.
(See Figure 19)
Figure 19
4. Once a month or as necessary, hand or machine
wash the micro cloth filter and let it air dry. Do not
put it in the dryer. (See Figure 20)
Figure 20
PAGE 6 OF 24

FILTER MAINTENANCE

Intercept®
Micro Filter
Micro Cloth
Filter
DOME FILTER
1. Once a week, or as necessary, clean the dome filter.
2. First, remove the Intercept® Micro Filter and cloth
filter. Reach into the vacuum body and pull the top
piece of the dome filter off and remove the foam
media. (See Figure 21)
Figure 21
3. Shake out the foam, rinse it and let it air dry
thoroughly. (See Figure 22)
Figure 22
4. Once dry, replace the foam and firmly snap the top
of the dome filter into place.
HEPA EXHAUST FILTER
1. Once every two weeks or as necessary, inspect the
HEPA filters. When the filter becomes discolored,
replace it with a new filter. For best results, this filter
should be replaced every six months.
2. To inspect or replace the HEPA filter, turn the tab
clockwise to open the filter door. Grasp the plastic
housing on the HEPA filter to remove. (See Figure 23)
Figure 23
3. To replace the filter door, align the tabswith the slots
in the housing close. Be sure to close the door firmly
and turn the tab counterclockwise to lock. You should
hear an audible click if closed correctly.
0421 IH-5048