Use And Maintenance; Handle Adjustment; Changing The Dust Bag - Uline SANITAIRE Manual Del Usuario

HANDLE ADJUSTMENT

1. With the tip of the foot, press down on the hood
while moving the handle backwards to adjust to the
desired position. The unit can lay completely flat for
cleaning under low furniture. (See Figure 8)
Figure 8
POWER SWITCH
2. The power switch is located on the left side of
the switchbox. The on/off switch is marked with
international symbols, (-) means on, (o) means off.
Press down on the front of the switch to turn the
cleaner on, press down on the back of the switch to
turn the unit off. (See Figure 9)
Figure 9
MAINTENANCE
CAUTION! Turn off the switch and unplug the
electrical cord before maintenance.
PAGE 3 OF 16

USE AND MAINTENANCE

CHANGING THE DUST BAG

3. Grasp the top of the outer bag and pull dual zipper
4. Pull the dust bag collar forward and remove the
ON
OFF
HOW TO REPLACE A WORN BELT OR BRUSHROLL
5. Release the cam lock and remove the bottom plate.
WARNING! Never operate the cleaner without
the dust bag.
connector down to the bottom of the outer bag.
Release the bag cap by smoothly lifting up and
rotating it towards the front of the bag. (See Figure 10)
Figure 10
dust bag. Place new dust bag collar on the flange
and rotate up until the tabs of the flange fasten into
the holes of the dust bag cover. Tuck the bottom
of the dust bag into the lower portion of the outer
bag. Replace the bag cap and pull up on the dual
zipper connector to secure the front of the outer
bag. (See Figure 11)
Figure 11
CAUTION! Belt pulleys can become hot during
normal use. To prevent burns, avoid touching
the belt pulley when servicing the drive belt.
(See Figure 12)
Figure 12
0421 IH-2549