DeWalt DW970 Manual De Instrucciones página 12

Drilling in Metals
Use a cutting lubricant when drilling metals. The exceptions are
cast iron and brass which should be drilled dry. The cutting
lubricants that work best are sulphurized cutting oil or lard oil;
bacon grease will also serve the purpose.
Drilling in Masonry
Use carbide tipped masonry bits at low speeds. Keep even force
on the drill but not so much that you crack the brittle materials. A
smooth, even flow of dust indicates the proper drilling rate.
Operation as a Screwdriver
Select the desired speed/torque range using the dual range gear
shift lever on the top of tool to match the speed and torque to the
planned operation.
Insert the desired fastener accessory into the Quick Release
Chuck. Set the torque adjustment collar (Figure 5). Make a few
practice runs in scrap or unseen areas to determine the proper
position of the clutch collar.
Maintenance
CLEANING: With the motor running, blow dirt and dust out of all
air vents with dry air at least once a week. Wear safety glasses
when performing this. Exterior plastic parts may be cleaned with a
damp cloth and mild detergent. Although these parts are highly
solvent resistant, NEVER use solvents.
Charger Cleaning Instructions:
WARNING: Disconnect the charger from the AC outlet before
cleaning. Dirt and grease may be removed from the exterior of the
charger using a cloth or soft non-metallic brush. Do not use water
or any cleaning solutions.
Accessories
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If
All manuals and user guides at all-guides.com
you need assistance in locating any accessory for your tool,
contact: D WALT Industrial Tool Co., 701 East Joppa Road,
E
Baltimore, MD 21286.
CAUTION: The use of any other accessory not recommended
for use with this tool could be hazardous.
Important
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment (including brush inspection and
replacement) should be performed by authorized service centers or
other qualified service organizations, always using identical
replacement parts.
Full Warranty
D WALT heavy duty industrial tools are warranted for one year from
E
date of purchase. We will repair, without charge, any defects due to
faulty materials or workmanship. For warranty repair information, call
1-800-4-D WALT. This warranty does not apply to accessories or
E
damage caused where repairs have been made or attempted by
others. This warranty gives you specific legal rights and you may
have other rights which vary in certain states or provinces.
In addition to the warranty, D
30 DAY NO RISK SATISFACTION GUARANTEE
If you are not completely satisfied with the performance of your
D WALT heavy duty industrial tool, simply return it to the
E
participating seller within 30 days for a full refund. Please return the
complete unit, transportation prepaid. Proof of purchase may be
required.
FREE WARNING LABEL REPLACEMENT: If your warning labels
become illegible or are missing, call 1-800-4-DEWALT for a free
replacement.
8
WALT tools are covered by our:
E