Axis T93C10 Manual De Instrucciones página 13

• Use only one cable per cable gland port.
• Use only round cables.
How to prepare the cable glands
1. Remove the external nut to expose the cable glands.
2. Push out the washer through the cable gland, from the inside of the housing. Use a
blunt tool.
How to attach the cable glands
1. Thread the nut on the cable.
2. Thread the washer on the cable.
3. Pull the cable through the cable gland, into the housing.
4. Pull the washer into the cable gland.
5. Attach the nut. Make sure it is properly sealed.
1
Cable gland
2
Washer
3
Nut
AXIS T93C10 Outdoor Housing
13
EN