How To Connect Power; How To Connect The Network; How To Prevent Moisture In The Housing; How To Pan And Tilt The Housing - Axis T93C10 Manual De Instrucciones

AXIS T93C10 Outdoor Housing

How to connect power

1. Connect 24 V DC to the red terminal of the terminal block.
2. Connect (-) DC ground wire to the black terminal of the terminal block.
3. Tighten firmly with a small flat screwdriver.

How to connect the network

1. Connect the network cable to the camera's network connector (PoE). See instructions in
the camera's Installation Guide.

How to prevent moisture in the housing

To prevent moisture inside the housing, add the humidity control pack.
1. Remove the plastic package from the humidity control pack.
2. Place the humidity control pack behind the camera in the housing.

How to pan and tilt the housing

To access the live view stream, find the camera on the network and log in to the camera's webpage.
For tilt adjustment:
1. Loosen the screw in the pan-tilt knuckle.
2. Adjust the housing into position.
3. Attach the screw.
For pan adjustment:
1. Loosen the two screws on both sides of the wall mount.
2. Adjust the housing into position.
3. Attach the screws.

How to adjust zoom

1. Log in to the camera's webpage.
2. Zoom the lens by turning the zoom ring on the lens with your fingers.
3. Lock the zoom position with the supplied elastic.
14