sunjoe SWD16000 Manual Del Operador página 10

Air Flow Regulating Block
• Used for the auxiliary regulation of suction force; when
the air flow regulating block opens, suction will decrease
gradually (Fig. 9).
• When the air flow regulating block is closed, the suction
force reaches the maximum value
Fig. 9
Air flow
regulating
block
Releasing and Assembling the
Power Head
m
WARNING!
To prevent personal injury, make sure the
switch is in the OFF position and the unit is unplugged before
attaching or removing the power head.
1. To release the power head, grab the two lid locks and pull
outside to unlock. Then remove the power head
(Fig. 10).
Fig. 10
Lid lock
2. To attach the power head, insert the tabs on each side of
the collection tank into the lid lock slots, and push firmly
to make sure the tabs are locked inside of the lid locks.
NOTE: The power head must be attached any time the
unit is being operated.
Maintenance
To order genuine replacement parts or accessories for the
Sun Joe
sunjoe.com or contact the Snow Joe
service center at 1-866-SNOWJOE (1-866-766-9563).
m
WARNING!
performing any maintenance task.
If the power is still connected, the unit could be accidentally
turned on while you are performing maintenance on it,
which could result in personal injury.
Cleaning The Dust Tank
Clean the equipment routinely after each use:
1. Take the unit outside to clean it to avoid creating a
mess indoors.
2. Remove the power head and empty the dust tank.
Clean the tank with water and allow it to dry completely.
3. The tank must be drained and cleaned every time after
vacuuming. Remove the drain outlet cap by turning it
clockwise and use the drain outlet to drain the liquid
waste in the tank (Fig. 11).
Fig. 11
Power head
Cleaning the HEPA filter
m
WARNING!
turn the unit off and unplug it before cleaning or servicing.
The HEPA filter included is made of high quality material
designed to stop small dust particles. The filter should be used
for dry pick-up only. If the dust filter is wet, it will clog quickly
and be very difficult to clean. Handle the filter carefully when
removing it for cleaning and replacing. Check the filters for
tears or small holes, a small hole can let dust pass through
and out of the cleaner. Do not use a filter with holes or tears,
replace it immediately.
1. Switch off and unplug the unit.
2. Remove the power head from the collection tank.
10
SWD16000 electric wet/dry vacuum, please visit
®
Disconnect the power cord before
Drain outlet cap
To avoid serious personal injury, always
+ Sun Joe customer
® ®