Service And Support - sunjoe SWD16000 Manual Del Operador

Service and Support

If your Sun Joe SWD16000 electric wet/dry vacuum requires
®
service or maintenance, please call the Snow Joe
customer service center at 1-866-SNOWJOE
(1-866-766-9563).
Troubleshooting
m
WARNING!
Always unplug the power cord before performing any adjustments, maintenance or repairs to your
electric wet/dry vacuum.
Problem
Device does not start
Dust comes out from
motor cover
+ Sun Joe
®
Possible Cause
Mains voltage is not present
The equipment is not switched ON
The collection tank is full
Defective appliance cord or ON/OFF switch
Defective motor
The HEPA filter is missing or damaged
There is a blockage in the nozzle, hose, or
air inlet. The HEPA filter is clogged by fine dust
Model and Serial Numbers
When contacting the company, reordering parts or arranging
service from an authorized dealer, you will need to provide the
®
model and serial numbers, which can be found on the decal
located on the housing of the unit. Copy these numbers into
the space provided below.
Record the following numbers from the housing or handle of your
new product:
S W D 1 6 0 0 0
Possible Solution
Check power supply – cord, breakers, fuses.
If damage is found, contact a qualified
electrician to repair
Switch on the equipment
Empty the collection tank
Contact Snow Joe
1-866-SNOWJOE (1-866-766-9563) to repair
Attach or replace the HEPA filter
Check the unit for blockage. Clean or
replace the HEPA filter
12
Model #:
Serial #:
customer service at
®