Cleaning The Foam Filter - sunjoe SWD16000 Manual Del Operador

3. With the removed power head in the upside down
position, carefully remove the HEPA filter from the filter
cage (Fig. 12).
Fig. 12
HEPA filter
4. Clean the HEPA filter by gently tapping or brushing dirt off.
Cleaning should not be done indoors in living areas.
5. If needed, use a mild soap and water solution to wash the
HEPA filter and rinse with clean water. Allow the wet filter
to air dry for 24 hours before installing onto the filter cage.
m
WARNING!
The HEPA filter must be installed before dry
vacuuming again.

Cleaning the Foam Filter

m
WARNING!
The foam filter must be cleaned every time
after wet vacuuming.
1. Switch off and unplug the unit.
2. Remove the power head from the collection tank.
3. With the removed power head in the upside down
position, carefully remove the foam filter from the filter
cage (Fig. 13).
Fig. 13
4. Use a mild soap and water solution to wash the foam filter
5. To assemble the filter, fit the foam filter on the filter cage
Storage
1. Examine the electric wet/dry vacuum thoroughly for worn,
2. Examine the appliance cord thoroughly for signs of
3. Store the wet/dry vacuum indoors in a clean, dry and
4. When not in use, the equipped tubes, handles and nozzles
Foam filter
Onboard accessories
storage
11
and rinse with clean water. Allow the wet filter to air dry for
24 hours before installing onto the filter cage.
(Fig. 14).
Fig. 14
Foam filter
loose or damaged parts. Should you need to repair or
replace a part, contact an authorized Snow Joe
Sun Joe dealer or call the Snow Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563) for assistance.
excess wear or damage. If it is worn or damaged,
replace it immediately.
locked location out of the reach of children and animals.
can be temporarily stored in the onboard vacuum hose +
power cord storage and onboard accessories storage
(Fig. 15).
Fig. 15
+
®
+ Sun Joe
® ®
Onboard vacuum hose +
power cord storage