Hkoenig gino536 Manual De Instrucciones página 6

The appliance must not be used near flammable materials. (Petroleum based products, thinners or any
other solid object that carries a flammable warning label.)
The use of this appliance in enclosed areas can be dangerous and is PROHIBITED.
INSTRUCTIONS FOR USE
Follow these instructions carefully to avoid seriously damaging your pizza oven and causing injury to
yourself and to property.
1.
Assemble the pizza oven by following the assembly instructions carefully.
2.
Connect the gas hose to the pizza oven. Connect the regulator to the hose.
3.
Connect the regulator to the cylinder valve following the regulator instructions supplied with the
regulator.
4.
Turn all of the control knobs to the 'OFF' position before turning on the gas supply to the
appliance.
5.
Operate the regulator in accordance with the instructions supplied with the regulator.
LIGHTING YOUR PIZZA OVEN
1.
Open the door before lighting.
2.
Connect the gas cylinder to the pizza oven following the instructions supplied with the regulator.
3.
Turn the control knob to the 'OFF' position.
4.
Turn 'ON' the gas supply at the cylinder or regulator switch following the regulator connection
and operating instructions. Check the cylinder to regulator connection and hose to pizza oven hose
inlet connection for leakage using soapy water. Any leakage will show as bubbles in the area of the
leak. If leak is found, do not use the pizza oven. Consult your gas or pizza oven supplier for advice.
5.
To light the burner, push down the control knob and keep pressing whilst turning anti- clockwise
to the "Full rate" position and press the ignition button waiting for 5 seconds. This
will light the burner. Check that the burner is alight. If the burner has not lit, repeat this process.
6.
If the burner has not lit after two attempts, turn 'OFF' the gas tap and wait 5 minutes before
retrying the ignition sequence.
7.
When the burner has lit, the burner rate can be adjusted by push down and turn the knob anti-
clockwise to any position between the full and low rate position.
8.
To turn 'OFF' the pizza oven, turn the cylinder valve handle or regulator switch to the 'OFF'
position by following the regulator instructions. Once the burners have extinguished turn all the control
knobs to the 'OFF' position.
Warning: If the burner fails to ignite, turn the control knob off (clockwise) and also turn the
cylinder valve off. Wait five minutes before attempting to relight with ignition sequence.
After use, close the gas supply by either turning 'OFF' the switch on the regulator or turning 'OFF' the
cylinder valve.
In the event of light back whilst the appliance is in use. Turn the control, cylinder valve and regulator
switch to the 'OFF' position. Wait 5 minutes before attempting to relight the appliance. If the problem
persists after relighting, consult your gas dealer, or the store where you purchased the pizza oven, or
a qualified gas engineer for assistance or repair. Never try to rectify the problem yourself as this could
result in serious injury and/or property damage.
Clean the appliance of excess fat, before storage, with a damp cloth using a mild detergent solution as
the cleaning agent.
Store the appliance in a clean dry environment.
Do not store your gas cylinder indoors. Store in a well ventilated area away from direct sunlight.
6/7