Water Connection - Weka SR 25 Manual De Instrucciones

reaching this operating time, the start button has to be pressed three times for starting the motor.
Now bring the machine to a WEKA service station for inspection, so that the machine can be
maintenanced and the counter can be set back. Do not work longer than 20 hours now in your
own interest, as you may loose any warranty claims.
Damaged PRCDs and plugs have to be repaired or exchanged exclusively in an authorized repair station
(www.weka-elektrowerkzeuge.de).
A damaged cable has to be replaced by a special prepared cable that can be purchased in an authorized
repair station.
6.1 Oil bath gear
The SR-machine possesses as all WEKA machines an oil bath gear. Through the special efficient
lubrication, a high duration of life can be reached. Especially take care foe leakages.
If you should realize that oil escapes, stop the machine immediately and send it for a check to one of
our repair stations or directly to us. You can find the addresses on our homepage.
Damaged PRCDs and plugs have to be repaired or exchanged exclusively in an authorized repair station
(www.weka-elektrowerkzeuge.de).
A damaged cable has to be replaced by a special prepared cable that can be purchased in an authorized
repair station.
6.2

Water connection

If water escapes from the overflow hole on the water connection ring (item 505), the rotary shaft seals
are to be replaced immediately. This should only be done in an authorized specialist workshop.
7. G U A R A N T E E
We will guarantee the WEKA core drilling machine for 12 months from the day of delivery. During this
period we will rectify material and production defects free of charge. This warranty does not cover normal
wear and tear, overloading, non-compliance with the operating instructions and intervention by
unauthorized persons or the use of parts from other companies. Further more wearing parts as rotary
shaft seals, overload clutch and ON-OFF button are not covered by warranty.
8. D E C L A R A T I O N O F C O N F O R M I T Y
Description:
Type:
from serial no.:
We hereby declare under our sole responsibility that this product conforms with the following standards:
EN55014-1, EN55014-2, EN61000-3-2, EN61000-3-3, EN60204-1 (SR65/68/75), EN 62841-1 (SR25/38),
EN 62841-3-6 (SR25/38) in accordance to the regulations of directive 2006/42/EG, 2011/65/EU and
2014/30/EU.
WEKA Elektrowerkzeuge
Auf der Höhe 20
D 75387 Neubulach
9. R E C Y C L I N G
According to the European regulation 2002/96/EG we have to take back old machines for
departing them by substance and for recycling. Please make sure that the old tool does not
get into the unsorted municipal solid waste, but that they are given back to us, resp. abroad
to our distributors.
Diamond core drill - for drilling holes in concrete, stone and masonry
SR25, SR38, SR65, SR68, SR75 (and versions)
0113001
Neubulach, 14.01.2019
Daniel Schrade, Managaing Director
Original instructions - Subject to change without notice 0119
21