Electrical Safety - sunjoe 24V-X2-21LM Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

14. Keep cutting blade sharp and clean – Properly
maintained cutting blades with sharp edges are less likely
to bind and are easier to control.
15. Keep all parts of the body away from the cutting blade
– Do not remove cut material or hold material to be cut
when blade is moving. Make sure the switch is off when
clearing jammed material. A moment of inattention while
operating the product may result in serious personal injury.
16. If the lawn mower strikes a foreign object, follow
these steps:
i) Stop the lawn mower by releasing the switch lever.
ii) Remove the batteries and the safety key.
iii) Inspect for damage.
iv) Repair any damage before restarting and operating
the lawn mower.
17. Only use identical replacement blades and other genuine
parts.
18. Keep guards in place and in proper working order.

Electrical Safety

1. If the battery charger cable is damaged, please call the
Snow Joe
+ Sun Joe
®
®
1-866-SNOWJOE (1-866-766-9563).
2. If charging the power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected power supply. The using of an RCD reduces the
risk of electric shock.
3. Avoid body contact with earthed or grounded surfaces
such as pipes, radiators, ranges and refrigerators. There is
an increased risk of electric shock if your body is earthed
or grounded.
4. Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of
electric shock.
5. Do not abuse the charging cord. Never use the cord
for carrying, pulling or unplugging the charger. Keep
cord away from heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the risk of
electric shock.
6. Battery charger is for indoor use only. Do not charge
batteries in rain, or in wet locations.
customer service center at
Battery + Charger
Safety Instructions
We pay a great deal of attention to the design of every battery
pack to ensure that we supply you with batteries that are safe,
durable and have a high energy density. The battery cells have
a wide range of safety devices. Each individual cell is initially
formatted and its electrical characteristic curves are recorded.
This data is then used exclusively to be able to assemble the
best possible battery packs.
Despite all the safety precautions, caution must always be
exercised when handling batteries. The following points must
be obeyed at all times to ensure safe use. Safe use can only
be guaranteed if undamaged cells are used. Incorrect handling
of the battery pack can cause cell damage.
IMPORTANT! Analyses confirm that incorrect use and poor
care of high-performance batteries are the main factors
responsible for personal and/or product damage.
m
WARNING!
Use only approved replacement batteries;
other batteries may damage the lawn mower and cause it to
malfunction, which can lead to serious personal injury.
m
CAUTION!
To reduce the risk of injury, charge the
iON+ 24V lithium-ion battery packs only in the designated
iON+ 24V lithium-ion charger. Other types of chargers present
risk of fire, personal injury and damage. Do not wire the battery
packs to a power supply plug or car cigarette lighter. Such
misuse will permanently disable or damage the battery packs.
• Avoid dangerous environments – Do not charge the
battery packs in rain, snow or in damp or wet locations.
Do not use the battery packs or charger in the presence of
explosive atmospheres (gaseous fumes, dust or flammable
materials) because sparks may be generated when inserting
or removing the battery packs, which could lead to a fire.
• Charge in a well-ventilated area – Do not block the
charger vents. Keep them clear to allow for proper
ventilation. Do not allow smoking or open flames near
charging battery packs. Vented gases may explode.
NOTE: The safe temperature range for the batteries are
41°F (5°C) to 104°F (40.5°C). Do not charge the batteries
outside in freezing weather; charge it at room temperature.
• Maintain charger cord – When unplugging the charger, pull
the plug, not the cord, from the receptacle to reduce the
risk of damage to the electrical plug and cord. Never carry
the charger by its cord or yank it by the cord to disconnect
it from the receptacle. Keep the cord away from heat, oil
and sharp edges. Make sure the cord will not be stepped
on, tripped over or subjected to damage or stress when the
charger is in use. Do not use the charger with a damaged
cord or plug. Replace a damaged charger immediately.
2

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido