Silver Luxury-Lift ® Power Recliner Troubleshooting; Furniture Placement Guide - La-Z-Boy Silver Luxury-Lift Instrucciones De Operación

Silver Luxury-Lift
Troubleshooting
WARNING
– To reduce the risk of serious injury:
• Do not attempt to disassemble or service the pump or motor; no serviceable parts are
inside. Contact your La-Z-Boy dealer for service.
®
• Check the condition of the power transformers, electrical cords, plugs and connectors
monthly. Keep the power transformers and electrical cords away from heat sources.
Never operate the unit with a damaged power transformer, electrical cord, plug or
connector. Contact your La-Z-Boy
• The 4LP lift chairs are intended for a single occupant, not exceeding 325 pounds.
Do not operate the chair with more than one occupant in or on any part of the chair.
Troubleshooting for Legrest Operation
If the legrest stops moving while closing, and all other functionality of the lift chair is operating,
the legrest may have encountered an obstruction and disengaged from the mechanism.
1. Check to make sure there are no obstructions. Lift and hold the legrest up, look for obstructions
and remove them.
2. Firmly push the legrest closed with your legs; you will hear a "pop" when the legrest
is reconnected to the mechanism.
If there are no obstructions and the legrest still does not close properly, contact your La-Z-Boy
dealer for service.
Troubleshooting for Lift and Recline Operation
If the recline or lift features do not work, check the following:
1. Make sure the 120 volt power cord is plugged into an electrical outlet.
2. Check the power transformer to make sure the green LED power indicator light is on.
3. Make sure the electrical outlet is working. For example, make sure there are no blown
fuses or tripped circuit breakers.
4. Make sure all the connections are secure; refer to the Assembly Instructions.
5. Make sure the electrical cords are not crimped or pinched. Make sure the electric
cord or plug is not damaged.
6. Make sure the operating capacity has not been exceeded and there is only one
occupant in the chair; refer to the Operating Instructions.
Power Transformer Replacement
If the power transformer must be replaced:
1. Unplug the power transformer from the electrical outlet.
2. Disconnect the 120 volt power cord from the power transformer, and disconnect the power
transformer from the power supply connector. Refer to the Assembly Instructions.
3. Connect the new power transformer to the power supply connector; align the connectors and
push together until locked. Connect the 120 volt power cord to the new power transformer; align
the connector to the power transformer and push together until fully seated. Refer to the
Assembly Instructions.
4. Proceed to the Battery Backup Assembly Instructions.
16
Power Recliner
®
dealer for service.
®
WARNING
• Provide a clear path for operation of the back and legrest. Place tables and area rugs
at a distance to allow the legrest to fully extend without rubbing or interference.
To place your reclining unit the proper distance from the wall, fully recline the unit and leave
a minimum of 2" of space between the top of the back and the wall.
Place tables and area rugs at a distance to allow the legrest to fully extend without rubbing
or interference.
®

Furniture Placement Guide

– To reduce the risk of serious injury:
17