Safety Devices; Oven; Safety Thermostat; Instructions For Installation - LIBRETTO EM E6/11-D Instalación, Uso, Mantenimiento

SEPARATE COLLECTION OF THIS UNIT AT THE END OF ITS LIFE CYCLE IS MANAGED BY
THE MANUFACTURER.
USERS THAT WISH TO DISPOSE OF THIS APPLIANCE MUST CONTACT THE
MANUFACTURER AND FOLLOW INSTRUCTIONS TO COMPLY WITH THE SYSTEM
ADOPTED BY THE MANUFACTURER TO ENSURE PROPER WASTE SORTING AT THE END
OF THE APPLIANCE'S USEFUL LIFE.
PROPER WASTE SORTING CONTRIBUTES TO PREVENTING POTENTIALLY NEGATIVE
IMPACTS ON THE ENVIRONMENT AND ON HUMAN HEALTH, ENCOURAGING THE REUSE
AND/OR RECYCLING OF THE MATERIALS COMPOSING THE EQUIPMENT.
ABUSIVE DISPOSAL OF THE PRODUCT BY THE HOLDER WILL RESULT IN THE
APPLICATION OF PENALTIES AS PER CURRENT STANDARDS.

2. SAFETY DEVICES

OVEN

SAFETY THERMOSTAT

THE MANUFACTURER WILL NOT BE LIABLE FOR ANY DAMAGE OR INJURY RESULTING
FROM FAILURE TO OBSERVING THE FOLLOWING RULES.
The appliance is equipped with a manual reset safety thermostat that interrupts heating when the
operating temperature exceeds the maximum permitted value.
To restore appliance operation, remove the control panel and press the thermostat reset button. This
procedure must only be carried out by a qualified, authorized technician.

INSTRUCTIONS FOR INSTALLATION

II.

3. REMINDERS FOR THE INSTALLER

READ THIS MANUAL CAREFULLY. IT PROVIDES IMPORTANT INFORMATION FOR SAFE
INSTALLATION, USE AND MAINTENANCE OF THE APPLIANCE.
FAILURE TO COMPLY WITH WHAT IS PRESENTED BELOW MAY COMPROMISE THE
SAFETY OF THE EQUIPMENT.
THE MANUFACTURER WILL NOT BE LIABLE FOR ANY DAMAGE OR INJURY RESULTING
FROM FAILURE TO OBSERVING THE FOLLOWING RULES.
Identify the specific appliance model. The model number is detailed on the packing and on the
appliance dataplate.
The appliance must be installed in a well-ventilated room.
Installation and conversion to a different type of gas must be carried out by qualified technicians
authorized by the manufacturer, in compliance with current safety standards and the instructions in
this manual.
Appliance maintenance and conversion to a different type of gas must be carried out by qualified
20