Troubleshooting; Product Maintenance - HAMPTON BAY Y38019GU24-279 Manual De Instrucciones

TROUBLESHOOTING:

Light will not turn on.
Fuse blows or circuit breaker
trips when light is turned on.
The light does not turn on at
night.
The light remains on during the
daytime.

PRODUCT MAINTENANCE:

1. To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to 1 To clean the outside of the fixture use a dry or slightly dampened clean cloth (use clean water never a solvent) to
wipe the glass and surface of the fixture.
2. To clean the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by
removing the fuse at the fuse box. Next, use a dry or slightly dampened clean cloth (use clean water, never a
solvent) to wipe the inside glass and interior surface of the fixture.
3 3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft cloth to dust or wipe D t l
carefully.
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of
three (3) years from date of purchase. This warranty applies only to the original consumer purchaser and only to
products used in normal use and service. If this product is found to be defective, the manufacturer s only obligation, products used in normal use and service If this product is found to be defective the manufacturer's only obligation
and your exclusive remedy, is the repair or replacement of of the product at the manufacturer's discretion, provided that
the product has not been damaged through misuse, abuse, accident, modifications, alterations, neglect or mishandling.
This warranty shall not apply to any product that is found to have been improperly installed, set-up, or used in any way
not in accordance with the instructions supplied with the product. This warranty shall not apply to a failure of the
product as a result of an accident, misuse, abuse, negligence, alteration, or faulty installation, or any other failure not
relating to faulty material or workmanship. This warranty shall not apply to the finish on any portion of the product,
such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant h f d/
and specially disclaims any warranty, whether expressed or implied, of fitness for a particular purpose, other
than the warranty contained herein. The manufacturer specifically disclaims any liability and shall not be liable
for any consequential or incidental loss or damage, including but not limited to any labor/expense costs involved
in the replacement or repair of said product.
Page 8
Possible Cause
1. Power is off.
2. Faulty switch.
3. Faulty wire connection.
1. Crossed wires or power wire is grounding out. 1. Check wire connections.
Too much sunlight is shining onto the photocell
sensor in the early evening.
Too much light is shining onto photocell sensor
due to another light source, such as a street lamp
or other light fixture.
The fixture may be installed in a shaded area, such Th fi t b i t ll d i
as under a porch or eave, preventing daylight
from shining onto the photocell sensor.
ith h i l l
LIMITED WARRANTY
h i hi i id
h d d h
t h h b i U
d l d
Corrective Action
1. M ake sure power supply is on.
2. Test or replace switch.
3. Check wiring.
Rotate fixture so that the photocell sensor
points away from the west.
Eliminate or turn off other light source.
OR
Block other light source from shining onto
photocell sensor.
OR
Relocate fixture.
Relocate fixture.
l d ft l th t d t
Th f
i
d