Filter Installation - RIDGID RV2400HF0 Manual Del Usuario

SP6775-2 RV2400HF ESF RIDGID

Filter Installation

1. Make sure the gasket on the HEPA
filter and the sealing surface on the
power head are not damaged and are
clean and free of debris
2. Place the HEPA filter onto the filter
cage until the HEPA filter is snug
against the power head. Be sure the
filter cage's threaded stud protrudes
through the HEPA filter opening.
3. Position the filter washer with the
rubber side against the HEPA filter and
then place the filter wing nut onto the
threaded stud of the filter cage.
Hand-tighten the filter nut to secure the
HEPA filter to the power head.
Filter
Wing Nut
!
WARNING: Do not operate
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
4. Slide the pre-filter onto the assembled
HEPA filter.
6/27/12 12:00 PM
Filter Washer
HEPA
Filter
Lower
5. Position the filter band clamp on the
End Cap
Filter Cage
Power Head
NOTE: Damage to filter will occur if filter
band clamp is tightened around the filter
screen.
7
Page 7
pre-filter, over the lower end cap, as
shown. Tighten with a screwdriver to
secure.
Pre-Filter
Lower End
Cap
HEPA
Filter
Filter Band Clamp
Pre-Filter
Filter Band
Clamp
HEPA
Filter
Power Head
Pre-Filter
Filter Band
Clamp
Power
Head
Setscrew