Sordin SHARP Manual De Instrucciones página 6

To put the hearing protectors in standby position (Sordin SHARP-2): Lift the earmuffs out and up until
they lock in standby position. (Fig.6)
To put the hearing protectors in parking position (Sordin SHARP-2): Put the earmuffs in standby
position. Turn the hearing protectors rearward along the side of the helmet until they lock in the parking
position. (Fig. 7)
Do not press the earmuffs against the helmet shell as this can cause cracks around the side of the helmet.
(Fig. 1)
To attach/remove optional head padding (SHARP-1): The optional head padding can be attached/
removed. Open the velcro flap on the padding to remove it from the headband.
The hearing protector is equipped with integrated microphones. A boom microphone can be used in
noisy environments to decrease the noise during phone calls and two-way radio calls.
To assemble the boom microphone: Make sure that the hearing protector is off and connect the boom
microphone to the microphone input on the right earmuff. (Fig. 9)
To charge the battery: Connect the charger cable to the charger-jack on left earmuff. (Fig. 10) Connect
the USB-connector on the charger cable to a standard USB-charger.
Voice feedback: BEEP sound (Informs that the hearing protector is charging).
FUNCTIONS
Switch ON / OFF
Press and hold the multifunction [O] button (Fig. 11.5) for 3 seconds until voice feedback "POWER ON".
Voice feedback: - POWER ON (Informs that the hearing protector is ON)
- BATTERY LEVEL (Informs about battery charging level: FULL 75%; 50%; 25% or LOW)
- RADIO (Informs that the hearing protector is in FM Radio mode)
- CONNECTED (Informs that a phone or two-way radio is connected via Bluetooth)
Press and hold the multifunction [O] button (Fig. 11.5) for 3 seconds until voice feedback "POWER OFF".
Voice feedback: - POWER OFF (Informs that the hearing protector turns OFF)
NOTICE! If no function button is activated for 2 hours, the hearing protector goes to sleep mode and
prepares to turn off. Press any button within 10 seconds to return to the last mode. This is a battery
saving function.
Change MODE
Press and release the multifunction [O] button (Fig. 11.5) for 1 second to switch between FM Radio mode,
Headset mode and Ambient mode.
Voice feedback: - RADIO (Informs that the hearing protector is in FM Radio mode)
- HEADSET (Informs that the hearing protector is in Headset mode)
- AMBIENT (Informs that the hearing protector is in Ambient mode)
Adjust Volume
Click the [-] button (11.1) to adjust volume down or [+] button (11.2) to adjust volume up.
Voice feedback: - BEEP sound (Informs that the min or max volume level is reached)
NOTICE! Each function mode, Radio, Headset, Ambient and Phone call has individual volume. The chosen
volume in Ambient mode will follow the mixed ambient sound in the other modes. The ambient sound is
level-dependent to protect from harmful noise.
Push to Listen (switch on/off ambient sound)
In RADIO and HEADSET mode, click [..] button to switch on/off ambient sound.
Bluetooth pairing
The hearing protector can be paired with Bluetooth
Select Headset mode (See Change MODE).
Press and hold the multifunction [O] button (Fig. 11.5) and [>] button (Fig. 11.4) for 2 seconds to activate
pairing.
Voice feedback: - PAIRING (Informs that the hearing protector is in pairing mode)
Activate Bluetooth function on the phone or two-way radio and search for new units.
units that support A2DP, HFP and HSP profiles.
®
6